Additional STEP Warmfloor
System Components
STEP Warmfloor operates on low voltage AC/DC and is usually connected to a power supply, although it can also be run on solar or wind power. The radiant heating elements feature self-regulating technology, which acts like a sensor, maintaining an even heat distribution, while saving energy. A thermostat is used to maintain the desired temperature.
Thermostats
The STEP Touch® Thermostat offers the following benefits:
- Set it to your desired temperature at anytime
- Vary your floor temperature by room
- Save energy and enjoy reduced electric bills
STEP Touch Thermostat can be used in conjunction the STEP AC Power Supply or DC Controller.
Power Supplies
STEP Warmfloor manufactures premium Safety Extra Low Voltage (SELV) power supplies that are energy efficient, silent, and easy to install. Our EPI-LX and EPI-LX-R power supply series is designed to the highest safety standard with built-in circuit breakers. The load is divided on the interface board between separate circuits to provide SELV. Additionally, the EPI-LX-R has a built-in regulator board that serves as an intelligence switch to enable/disable the line voltage so that switching/pulsing does not harm the power supply’s toroidal coils.
FEATURES
- Designed to be easy to install and fit within the wall cavity
- “Soft” switching of toroidal transformers
- 20 EPI-LX-R power supplies can be activated from one controller
- Trusted and precise regulation technology
- Maximizes energy efficiency of the STEP Warmfloor system
- Field accessible for primary voltage changes
- The interface and regulator boards are RoHS compliant
- Primary voltage 120V, 208V or 240V AC or DC, 50/60 Hz
- Secondary voltage is standard at 24V, but can be special ordered for 12V up to 48V
- Circuit breakers on the primary and secondary side
- Each secondary circuit is rated not to exceed 25 amps, with a maximum output of 500 VA
- SELV circuits
Sizes and Weight
All models: Width: 6.9″ (185mm), Depth: 3.5″ (89mm)
| Height | Weight | |||||
|---|---|---|---|---|---|---|
| MODEL |
|
|
||||
| EPI-LX-R-500 |
|
|
||||
| EPI-LX-R-1000 |
|
|
||||
| EPI-LX-R-1500 |
|
|
||||
| EPI-LX-500 |
|
|
Accessories
STEP Warmfloor radiant heating system installation requires specific wires and connectors for ANSI/UL compliance. Click here to download our PDF for required and optional accessories.
XTENSION WIRE
#14, #12 or #10 AWG stranded tinned copper (TCu) PVC insulated wire, 300 Vac, 105°C. Extension wire is for field wiring from power supply to elements.
SIGNAL WIRE
3-conductor signal wire (red, green and black) to connect the thermostat to the AC Power Supply or DC Controller.
CONNECTOR & TAPE KIT (C&T-10)
Includes (10) CON-DB Crimp Connectors, (1) 15″ long piece of TAPE-1 Sealant Tape, (1) Label-1, (1) Label-2, and an installation brochure. Includes material to connect and seal five heating element strips to extension wires.
CRIMP TOOL (TOOL-PRO)
Used to crimp the CON-DB crimp connector. The TOOL-PRO ratchet crimp tool is required as it is specially designed to properly crimp CON-DB crimp connector.
OPTIONAL COMPONENTS
TERMINAL BLOCK (T-BLOCK) WITH ENCLOSURE
Two-pole, power terminal block enclosed in extruded aluminum profile w/ heat sink. Set screw lug terminals sized for #14-#4 AWG wires, terminal assignments – one HOT bar and one NEUTRAL bar. Both bars have four lugs.